BKI BLF-F Service Manual download pdf (Page 11)

Automatic Lift Fryer Installation

Initial Test and Adjustment

1. Fill pot with shortening to about one inch below the mark.

Use only high-quality shortening that has low moisture content, a high smoke

point and no additives.

Overfilling the fryer pot with shortening could lead to serious injury. Ensure that

the fryer pot is filled with shortening only to the fill mark when shortening is hot.

Do not use any shortening other than what is specified in this manual and do not

overfill the fryer pot.

2. Place the FILTER/OFF/FRY switch to the FRY position. The shortening should begin to heat and

begin to reach the fill mark inside the pot. Add more shortening as required to reach the fill mark.

Refer to the troubleshooting section if this does not occur.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 26 27

No comments

BKI BLF-F Service Manual Page 11